![]() ![]() Q: If you have problem with the device connection of bluetooth, please do the following?Ī: Please note: Can't connect the device in the system settings, run neje app, it will automatically connect. If you continue to press the button, the device will switch between pause and work. After the reset is completed, press the button again to preview the position. Restart the device, press the red button, and the device will reset. At this time, the device has stored your engraving data. This is a standard reference.Ī: Open the neje software and start a work, which can be completed or not. If it does not meet your expectations, you can use a flat-blade screwdriver to screw the lens to the bottom. It is recommended to use an object with a fixed thickness and place a gray cardboard on it to assist in adjusting the focus.ģ.Simply put the restricted inner thickness directly on the cutting platform. ![]() (Prepare a ruler)Ģ.Adjust the focus to a fixed height, refer to the picture above. The cutting and focusing methods are as follows:ġ.Step 1: Adjust the bottom of the module and the cut honeycomb panel to a fixed height, refer to the picture above. If it is mainly used for engraving, adjust the focus to a distance of 5mm below the light barrier then slide the laser through a 5mm spacer to use a fixed focus method If you use laserGRBL and lightburn software to adjust the focus, you need to enter a command: M3 S1 and give a motion command, for example: G0 x10 y10 f1000 so that low light can be lit ![]() NEJE software provides automatic low light.
0 Comments
Leave a Reply. |